Resistance Inspection
Note
1. Disconnect MAF/IAT sensor.
2. Measure the resistance between the MAF/IAT sensor terminals D and E using an ohmmeter.
Specification
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harnesses for open or short. (Continuity check)
Open circuit
- MAF/IAT sensor terminal D (harness-side) and PCM terminal 2E (harness-side)
- MAF/IAT sensor terminal E (harness-side) and PCM terminal 2H (harness-side)
Short circuit
- MAF/IAT sensor terminal E (harness-side) and power supply
- MAF/IAT sensor terminal D (harness-side) and power supply
- MAF/IAT sensor terminal D (harness-side) and body GND
Mazda 6 Service Manual: Windshield Defrosting and Defogging
Press the windshield defroster switch. In this position, the outside air position
is automatically selected, and the air conditioner automatically turns on. The air
conditioner will directly dehumidify the air to the front windshield and side windows.
Airflow amount will be increased.
WARNING
...
Mazda 6 Service Manual: Three-way catalytic converter (twc) inspection
Note
Make sure that no HO2S DTCs have been detected. If detected, this
inspection is not applicable for TWC inspection.
1. Connect the WDS or equivalent and monitor PIDs as following.
Monitor the right TWC using O2S11 PID for upstream HO2S and O2S12 PID
for downstream HO2S.
2. Be ...