Mazda 6 Owners Manual: Interior Care
WARNING
Do not spray water into the vehicle cabin:
Spraying water into the vehicle cabin is dangerous as electrical devices such as the audio and switches could get wet resulting in a malfunction or vehicle fire.
NOTE
- Do not wipe the interior using alcohol, chlorine bleach, or organic solvents such as thinner, benzene, and gasoline. Otherwise, it may cause discoloration or stains.
- Rubbing hard with a stiff brush or cloth may cause damage.
If the vehicle interior becomes soiled by any of the following, wipe it off immediately using a soft cloth.
Leaving it uncleaned could cause discoloration, stains, cracks, or peeling of the coating, and it will make it hard to wipe off later.
- Beverage or fragrance
- Grease or oil
- Soiling
- Seat Belt Maintenance
- Vinyl Upholstery Maintenance
- Plastic Part Maintenance
- Instrument Panel Top (Soft pad) Maintenance
- Active Driving Display Maintenance (Some models)
- Panel Maintenance
- Cleaning the Window Interiors
- Cleaning the Floor Mats
Plastic Part Maintenance
When cleaning the plastic lenses of the lights, do not use gasoline, kerosene,
rectified spirit, paint, thinner, highly acidic detergents, or strongly alkaline
detergents. Otherwise, these ch ...
Seat Belt Maintenance
1. Clean the soiled area by lightly dabbing it with a soft cloth soaked in a
mild detergent (approx. 5%) diluted with water.
2. Wipe off the remaining detergent using a cloth soaked in clean water ...
Other materials:
Mazda 6 Owners Manual: Brake pedal inspection
Brake Pedal Height Inspection
Verify that the distance from the carpet to the center of the upper surface
of the pedal pad is as specified.
Pedal height (reference value)
Brake Pedal Height Adjustment
1. Loosen locknut B and turn the bolt A until it does not contact the pedal.
2. Loosen l ...
Mazda 6 Owners Manual: Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along
the direction (1) shown in the figu ...