Mazda 6 Service Manual: Interlock cable inspection
1. Remove the interlock cable.
2. With the slider pin as shown in the figure, verify that the interlock cable moves freely.
- If a malfunction is found, replace the interlock cable.
Key interlock inspection
Verify that the ignition key cannot be pulled out except in P position.
If a malfunction is found, inspect the interlock cable. (See
INTERLOCK CABLE INSPECTION.)
...
Selector lever inspection
1. Turn the ignition switch to ON (engine OFF).
2. With the brake pedal depressed, verify that there is a "click" at each
range when shifted.
3. Verify that the selector lever can be shifted.
4. ...
Other materials:
Mazda 6 Service Manual: Remote handle lever removal/installation
4SD
1. To remove the remote wire, remove the trunk side trim.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
5HB
1. To remove the remote wire, remove the trunk side upper trim and trunk side
trim.
2. Remove in the order indicated in the table.
...
Mazda 6 Service Manual: Car-navigation unit removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Car-navigation Unit Installation Note
Insert the car-navigation unit bracket into the dashboard member hole, and
with the c ...