Vibration Method
Note
- Connectors not fully seated.
- Wire harnesses not having full play.
- Wires laying across brackets or moving parts.
- Wires routed too close to hot parts.
Connector Terminal Check Method
1. Check the connection condition of each female terminal.
2. Insert male terminal into the female terminals to check for looseness.
Mazda 6 Service Manual: Starter removal/installation
Warning
When the battery cables are connected, touching the vehicle body with starter
terminal B will generate sparks. This can cause personal injury, fire, and
damage to the electrical components. Always disconnect the battery negative
cables before performing the following operation.
1. Di ...
Mazda 6 Service Manual: Magnetic clutch adjustment
1. Measure the clearance around the entire circumference between the pressure
plate and A/C compressor pulley using a thickness gauge.
2. Verify that the clearance is within the specification.
If not within the specification, remove the pressure plate and adjust
the clearance by changing ...