Mazda 6 manuals

Mazda 6 Service Manual: Intermittent rear wiper relay inspection

Mazda 6 Service Manual / Body electrical system / Wiper and washer / Intermittent rear wiper relay inspection

1. Connect the connector to the intermittent rear wiper relay.

2. Connect the negative battery cable.

3. Measure the voltage at the intermittent rear wiper relay using voltmeter.

4. If the value are not as specified in the Terminal Voltage List (Reference), inspect the parts under Action and related wiring harnesses.

5. If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the intermittent rear wiper relay.

Terminal Voltage Table (Reference)




Intermittent rear wiper relay removal/installation
5HB 1. Disconnect the negative battery cable. 2. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. 4. Install in the reverse ...

Wiper and washer switch removal/installation
1. Disconnect the negative battery cable. 2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. 4. Install in the reverse order of ...

Other materials:

Mazda 6 Service Manual: Cargo compartment light switch inspection
1. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION) 2. Disconnect the cargo compartment light switch connector. 3. Inspect for continuity between the cargo compartment light switch terminals using an ohmmeter. If not as specified, replace the liftgate lock. ...

Mazda 6 Service Manual: Indication on Display
The Distance Recognition Support System (DRSS) operation status is indicated in the active driving display or multi-information display. Regarding malfunctions, check the vehicle conditions or have it inspected by an Authorized Mazda Dealer according to the content of the displayed message. R ...

© 2016-2024 Copyright www.mazda6info.net