Mazda 6 Service Manual: Key interlock inspection
Verify that the ignition key cannot be pulled out except in P position.
- If a malfunction is found, inspect the interlock cable. (See INTERLOCK CABLE INSPECTION.)
Shift-lock inspection
1. Turn the ignition switch to ON position.
2. Verify that the selector lever is in P position.
3. Depress the brake pedal and verify that the selector lever can be shifted
from P position.
If ...
Interlock cable inspection
1. Remove the interlock cable.
2. With the slider pin as shown in the figure, verify that the interlock
cable moves freely.
If a malfunction is found, replace the interlock cable.
...
Other materials:
Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...
Mazda 6 Service Manual: Jack
To remove the jack
1. Lift the trunk mat.
2. Remove the pocket.
3. Turn the wing bolt and jack screw counterclockwise.
To secure the jack
1. Insert the wing bolt into the jack with the jack screw pointing to the front
and turn the wing bolt clockwise to temporarily tighten it.
2. Turn ...