Mazda 6 Service Manual: Liftgate disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim.
3. To remove the liftgate outer handle and liftgate key cylinder, remove the rear finisher.
4. To remove the stud ball, separate the stud ball and the stay damper.
5. Disassemble in the order indicated in the table.
6. Assemble in the reverse order of disassembly.
STAY DAMPER DISPOSAL
Referring to procedures for trunk lid stay damper disposal, dispose of the liftgate stay damper.
Liftgate removal/installation
Warning
Removing the stay damper without supporting the liftgate can be
dangerous. The liftgate may fall and injure you. Open the liftgate fully and
support it before removing the stay dampe ...
Liftgate adjustment
1. Measure the gap and height between the liftgate and the body.
2. If not as specified, loosen the liftgate hinge installation bolts or the
liftgate striker installation screws, and reposition the ...
Other materials:
Mazda 6 Service Manual: Foreword
Outline
The OBD (on-board diagnostic) test inspects the integrity and function
of the air bag system and outputs the results when requested by the specific
tests.
OBD test also:
- Provides a quick inspection of the air bag system.
- Is usually performed at the start of each diagn ...
Mazda 6 Service Manual: Dtc c1095, c1096
Caution
When attaching the tester lead to the ABS (ABS/TCS) HU/CM harnesses
connector the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM
INSPECTION.)
Diagnostic procedure
...