Caution
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Stop Screw and O-ring (without ABS) Assembly Note
1. Install the secondary piston and primary piston.
2. Install the new O-ring onto the stop screw.
3. Push the primary piston assembly in full.
4. Install and tighten the stop screw.
Tightening torque 2.0-2.4 N·m {21-24 kgf·cm, 18-21 in·lbf}
5. Push and release the secondary piston component to verify that it is held properly by the stop screw.
Stop Pin and O-ring (with ABS) Assembly Note
1. Install the secondary piston with the piston hole facing the stop pin and primary piston.
2. Install the new O-ring onto the stop pin.
3. Push the primary piston assembly in full.
4. Install and tighten the stop pin.
Tightening torque 6.9-9.8 N·m {71-99 kgf·cm, 62-86 in·lbf}
5. Push and release the secondary piston component to verify that it is held properly by the stop pin.
Mazda 6 Service Manual: Sunroof relay inspection
Note
Sunroof relay is built in the sunroof motor.
1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
2. Connect the sunroof switch connector.
3. Measure the voltage at the sunroof relay terminals as indicated below.
4. Disconnect the sunroof relay connector before inspecting fo ...
Mazda 6 Service Manual: Dehumidifying (With air conditioner)
Operate the air conditioner in cool or cold weather to help defog the windshield
and side windows.
1. Set the mode selector dial to the desired position.
2. Set the air intake selector to the outside air position (indicator light turns
off).
3. Set the temperature control dial to the desired ...