1. Remove in the order indicated in the table.
R.H.D.
L.H.D.
2. Install in the reverse order of removal.
Master Cylinder Installation Note
Caution
1. Install the SST
to the power brake unit as shown, and tighten within the specified torque.
Tightening torque 9.8-16.0 N·m {100-163 kgf·cm, 87-141 in·lbf}
2. Using a vacuum gauge, create a vacuum pressure of 66.7 kPa {500 mmHg, 19.7 inHg}
in the power brake unit.
3. Using calipers, measure dimension L as shown.
Specification
22.7 mm{8.94 in}
4. If dimension L is not within the specification as shown, remove SST
(49 E043 001) and use SST
(49 B043 004) to adjust the length of the push rod while using SST
(E043 003A) to keep the push rod from rotating.
5. Remove the SSTs
, replace SST
(49 E043 001) and measure dimension L again.
6. Install the master cylinder to the power brake unit.
Caution
Mazda 6 Service Manual: Indicators
Manual shift mode indication
In manual shift mode, the “M” of the shift position indication in the instrument
panel illuminates.
Gear position indication
The numeral for the selected gear illuminates.
NOTE
If the gears cannot be shifted down when driving at higher speeds, the
gear ...
Mazda 6 Service Manual: Automatic Brake Operation Display (Type A Instrument Cluster)
“Smart City Brake Support activated” is indicated in the active driving display,
and “Smart City Brake Support Activated” is indicated in the multi-information display
after the SCBS brakes or the brake assist (SCBS brake assist) is operated.
NOTE
The collision warning beep sounds ...