Mazda 6 manuals

Mazda 6 Service Manual: Meter hood removal/installation

Mazda 6 Service Manual / Body / Dashboard and console / Meter hood removal/installation

1. Remove the screws.


2. Pull the meter hood toward you, then detach the column cover.

3. Install in the reverse order of removal.

Column cover removal/installation
1. Detach the fit of the upper column cover from the meter hood rubber. 2. Remove the upper column cover. 3. Remove the ignition key illumination. 4. Remove the screws. 5. Remove the lower colum ...

Lower panel removal/installation
1. Remove the bonnet release lever. 2. Remove the screws. 3. Pull the lower panel toward you, then disengage clips A and tabs B from the dashboard, and remove the lower panel. 4. Install in the ...

Other materials:

Mazda 6 Service Manual: Variable tumble control system (vtcs) shutter valve actuator inspection
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 2. Disconnect the vacuum hose from the VTCS shutter valve actuator. 3. Connect a vacuum pump to the VTCS shutter valve actuator. 4. Apply vacuum and verify that the rod moves. If the rod dose not move, replace the intake ...

Mazda 6 Service Manual: Exhaust system
EXHAUST SYSTEM INSPECTION Start the engine and inspect each exhaust system component for exhaust gas leakage. If leakage is found, repair or replace as necessary. EXHAUST SYSTEM REMOVAL/INSTALLATION Warning When the engine and exhaust system are hot, they can badly burn. Turn off t ...

© 2016-2024 Copyright www.mazda6info.net