Mazda 6 Service Manual: No.2 neither abs warning light nor brake system warning lightilluminate with ignition switch on

Mazda 6 Service Manual / Braking system / Troubleshooting (abs/tcs/dynamic stability control) / No.2 neither abs warning light nor brake system warning lightilluminate with ignition switch on

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harnesses are connected correctly and undamaged.

No.1 abs warning light, brake system warning light, tcs off light do not illuminate with ignition switch on

Vehicle with ABS/TCS When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact poi ...

No.3 abs warning light does not illuminate with ignition switch on

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Fuel Requirements
Vehicles with catalytic converters or oxygen sensors must use ONLY UNLEADED FUEL, which will reduce exhaust emissions and keep spark plug fouling to a minimum. This vehicle will perform best with fuel listed in the table. * U.S. federal law requires that octane ratings be posted on gasoline st ...

Mazda 6 Service Manual: HomeLink Wireless Control System (Some models)
NOTE HomeLink and HomeLink house icon are registered trademarks of Gentex Corporation. The HomeLink system replaces up to 3 hand-held transmitters with a single built-in component in the auto-dimming mirror. Pressing the HomeLink button on the auto-dimming mirror activates garage doors, gates ...