Mazda 6 manuals

Mazda 6 Service Manual: No.5 engine stalls-after start/at idle

Mazda 6 Service Manual / Fuel and emission control systems / Troubleshooting / No.5 engine stalls-after start/at idle


Diagnostic procedure





No.4 hard to start/long crank/erratic start/erratic crank
Diagnostic procedure ...

No.6 cranks normally but will not start
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Rear wheel alignment
Specification (Unloaded)*1 Normal Elevated*3 *1 : Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position. *2 : Difference between left and right must not exceed 1°30'. *3 : Distance between wheel center and fender brim is 392 mm {15.4 ...

Mazda 6 Service Manual: Refrigerant pressure switch inspection
1. Install the SST (gas charging set). 2. Disconnect the refrigerant pressure switch connector. 3. Verify the high-pressure side reading of the SST (manifold gauge) and continuity between the terminals of the refrigerant pressure switch. If not as specified, replace the refrigerant pressure ...

© 2016-2022 Copyright www.mazda6info.net