Mazda 6 Service Manual: No.9 noise while operating a/c system
Diagnostic procedure
* : If there is gas leakage, air enters into the A/C system. The desiccant within the receiver/drier absorbs the moisture from the air and becomes saturated. If the A/C system is used in this condition, the inside of the A/C compressor will begin to rust due to this moisture, which may cause lock up or noise to occur. Therefore, replacement of the receiver/drier is necessary.
No.8 no cool air
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor contact points are the cause o ...
Technical data
ENGINE
LUBRICATION SYSTEM
Note
The maintenance intervals on scheduled maintenance table (See
SCHEDULED MAINTENANCE TABLE) can only be supported by the use of following
oils.
Recomme ...
Other materials:
Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor inspection
On-Vehicle Inspection
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
Caution
Water or foreign objects entering the connector can cause a poor
connection or corrosion. Be sure not to drop water or foreign object ...
Mazda 6 Service Manual: Hazardous Driving
WARNING
Be extremely careful if it is necessary to downshift on slippery surfaces:
Downshifting into lower gear while driving on slippery surfaces is dangerous. The
sudden change in tire speed could cause the tires to skid. This could lead to loss
of vehicle control and an accident.
When dri ...