OIL FILTER REPLACEMENT
For Europe (LF and L3 engine models)
Caution
1. Remove the oil filter drain plug.
2. Untighten the oil filter cover for 2 turns and drain the engine oil.
Note
3. Remove the oil filter.
4. Use a clean rag to wipe off the mounting surface on the oil filter adapter and the oil filter cover.
5. Apply clean oil to new O-ring of a new oil filter and a new oil filter drain plug.
6. Install the oil filter, oil filter drain plug, and oil filter cover.
7. Tighten the oil filter cover and oil filter drain plug.
Tightening torque: Oil filter cover: 30-35 N·m {30.5-3.56 kgf·cm, 22.2-25.8 in·lbf} Oil filter drain plug: 9.0-11 N·m {91.8-112.1 kgf·cm, 79.6-97.3 in·lbf}
8. Start the engine and inspect for oil leakage.
9. Inspect the oil level.
Mazda 6 Service Manual: Cruise actuator inspection
1. Disconnect the cruise actuator connector.
2. Measure the voltage, continuity and resistance at the cruise actuator
terminals as indicated below.
If not as specified, inspect the parts listed under Action.
If the parts and wiring harnesses are okay but the system still does not
work pr ...
Mazda 6 Service Manual: Jack
To remove the jack
1. Lift the trunk mat.
2. Remove the pocket.
3. Turn the wing bolt and jack screw counterclockwise.
To secure the jack
1. Insert the wing bolt into the jack with the jack screw pointing to the front
and turn the wing bolt clockwise to temporarily tighten it.
2. Turn ...