OIL PAN REMOVAL/INSTALLATION
Warning
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Drain the engine oil. (See ENGINE OIL REPLACEMENT.)
4. Remove the engine front cover. (See TIMING CHAIN REMOVAL/INSTALLATION.)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Inspect the oil level. (See ENGINE OIL INSPECTION.)
8. Start the engine and inspect for oil leakage.
Oil Pan Installation Note
1. Use a square ruler to unite the oil pan and the cylinder block junction side on the engine front cover side.
2. Apply silicone sealant to the oil pressure switch threads as shown.
3. Tighten the bolts in the order shown.
Mazda 6 Service Manual: Rear seat disassembly/assembly
4SD
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
5HB
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
...
Mazda 6 Service Manual: Front shock absorber and spring removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-sensor (axle side) and fix it to an appropriate pl ...