Caution
On-vehicle Inspection (harness inspection)
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Disconnect the cord assembly connector.
4. Verify that there is no continuity between cord assembly terminal and ground.
5. Connect the cord assembly connector.
6. Install the under cover.
7. Connect the negative battery cable.
On-vehicle Inspection (oil pressure switch inspection)
1. Remove the under cover.
2. Disconnect the cord assembly connector.
3. Start the engine, with gear position in N or P.
4. Reaffirm that there is no continuity between cord assembly terminal and ground.
5. Firmly depress the brake pedal with the left foot.
6. Shift the selector lever to D range.
7. Verify that there is no continuity between cord assembly terminal and ground.
8. Connect the oil pressure switch connector.
9. Install the under cover.
10. Connect the negative battery cable.
Off-vehicle inspection
1. Remove the oil pressure switch.
2. Apply air pressure at 400-440 kPa {4.1-4.4kgf/cm2,58-63psi}
3. Inspect continuity the between oil pressure switch terminal and screw part.
4. Install the oil pressure switch.
Mazda 6 Service Manual: Operating Tips for CD Player
Condensation phenomenon
Immediately after turning on the heater when the vehicle is cold, the CD or optical
components (prism and lens) in the CD player may become clouded with condensation.
At this time, the CD will eject immediately when placed in the unit. A clouded CD
can be corrected sim ...
Mazda 6 Service Manual: Removal/Installation
To remove the head restraint, pull it up while pressing the stop-catch.
To install the head restraint, insert the legs into the holes while pressing
the stop-catch.
WARNING
Always drive with the head restraints installed when seats are being used
and make sure they are properly installed: Dri ...