1. Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.)
Caution
2. Remove the drive shaft. (See DRIVE SHAFT REMOVAL/INSTALLATION.)
3. Remove the oil seal.
4. Using the SST
and a hammer, tap a new oil seal in evenly until the SST
contacts the transaxle case.
5. Coat the lip of the oil seal with transaxle oil.
6. Install the drive shaft. (See DRIVE SHAFT REMOVAL/INSTALLATION.)
7. Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.)
8. Carry out the mechanical system test. (See MECHANICAL SYSTEM TEST.)
Mazda 6 Service Manual: Outside Temperature Display (Without Multi-information Display)
When the ignition is switched ON, the outside temperature is displayed.
NOTE
Under the following conditions, the outside temperature display may differ
from the actual outside temperature depending on the surroundings and vehicle conditions:
Significantly cold or hot temperatures.
Sudden ...
Mazda 6 Service Manual: Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the
connectors.
2. Measure the voltage at the theft-deterrent control module terminals as
indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting
for continuity at terminals L, Q, S, T, a ...