1. Start the engine and depress the brake pedal several times.
2. Stop the engine.
3. Remove the ashtray behind the center console.
4. Turn the adjusting nut as shown in the figure.
5. After adjustment, inspect the following points:
(1) Turn the ignition switch to ON, pull the parking brake lever one notch, and verify that the parking brake warning light illuminates.
(2) Verify that the rear brakes do not drag.
Mazda 6 Service Manual: Programming the HomeLink System
CAUTION
When programming a garage door opener or a gate, disconnect the power to these
devices before performing programming. Continuous operation of the devices could
damage the motor.
The HomeLink system provides 3 buttons which can be individually selected and
programmed using the transmi ...
Mazda 6 Service Manual: Dtc c1095, c1096
Caution
When attaching the tester lead to the DSC HU/CM connector the SST
(49 G066 004) must be used.
Diagnostic procedure
...