Warning
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove the glove compartment.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Turn the ignition switch to ON position.
7. Verify that the air bag system warning light illuminates for approximately 6 seconds
and then goes off.
Connector Removal Note
1. Using a flathead screwdriver, pry out the connector's stopper plate.
2. Disconnect the connector.
Mazda 6 Service Manual: Schedule 2
U.S.A. and Puerto Rico residents - Severe driving conditions maintenance interval
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
R: Replace
L: Lubricate
T: Tighten
Remarks:
*1 Engine oil flexible maintenance is available for U.S.A. and Pu ...
Mazda 6 Service Manual: Using Automatic Locking Mode (Some models)
Follow these instructions when using a child-restraint system, unless you are
attaching a LATCH-equipped childrestraint system to the rear LATCH lower anchors.
Refer to “Using LATCH Lower Anchor”.
NOTE
Follow the child-restraint system manufacturer's instructions carefully. If
you are no ...