1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle recognition.)
3. Select Module programming.
4. Select Programmable module installation.
5. Select PCM and perform procedures according to directions on the WDS screen.
Note
Note
6. Retrieve DTCs by the WDS or equivalent, then verify that there in no DTC present.
Mazda 6 Service Manual: Air filter inspection
1. Remove the air filter.
2. Inspect the air filter.
If the air filter is damaged, excessively dirty, or foul smelling,
replace the air filter.
Note
The air filter cannot be reused by cleaning it with water or
compressed air.
Replace the air filter at the following interval, depe ...
Mazda 6 Service Manual: Power steering fluid inspection
Fluid Level Inspection
1. Inspect the power steering fluid level.
Add fluid to the specified level as necessary.
Fluid specification
ATF M-III or equivalent (e.g. Dexron®II)
Fluid Leakage Inspection
1. Start the engine and let it idle.
2. Turn the steering wheel fully to the left and ...