Note
- CMP sensor (See CAMSHAFT POSITION (CMP) SENSOR INSPECTION.)
- Main relay (See RELAY INSPECTION.)
1. Connect the SST
(WDS or equivalent) to the DLC-2.
2. Turn the ignition switch to ON position.
3. Measure the PID value.
Note
- ACCS
- ALTF
- EVAPCP
- FAN1
- FAN2
- FAN3
- FP
- HTR11
- HTR12
- IAC
- IASV
- IMRC
- IMTV
- VT DUTY1
PID/DATA monitor table (reference)
*1 : Calculated value; differs from terminal voltage
*2 : Refrigerant pressure switch (middle) turns on when the refrigerant pressure is 1.691.84 MPa {17.318.7 kgf/cm2, 247265 psi}
*3 : Refrigerant pressure switch (middle) turns off when the refrigerant pressure is 1.261.49 MPa {12.915.1 kgf/cm2, 184214 psi}
*4 : L3 and L8, LF (Intensely hot area) models
*5 : Immobilizer system equipped
*6 : Immobilizer system not equipped
PIDs for the ATX models
- GEAR
- LINEDES
- LPS
- OP_SW_B
- SSA/SS1
- SSB/SS2
- SSC/SS3
- TCS
- TFT
- TFTV
- THOP
- TR
- TR_SENS
- TSS
Mazda 6 Service Manual: Hill Launch Assist (HLA)
Hill Launch Assist (HLA) is a function which assists the driver in accelerating
from a stop while on a slope. When the driver releases the brake pedal and depresses
the accelerator pedal while on a slope, the function prevents the vehicle from rolling.
The braking force is maintained automatic ...
Mazda 6 Service Manual: System wiring diagram
ABS (ABS/TCS)
DSC
FOREWORD
Before performing the steps in Symptom Troubleshooting, perform the
On-board Diagnostic Inspection. To check the DTC, follow the DTC Inspection
steps.
...