Note
1. Disconnect the negative battery cable.
2. For R.H.D, perform the following procedures.
(1) Remove the front side trim (left-side).
(2) Partially peel back the flower covering.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
U.K. specs.
European (L.H.D.) specs.
Set Nut/bolt Removal Note
1. Using a chisel and a hammer, cut a groove on the head of the set nut/bolt so that a screwdriver can be inserted.
2. Loose the set nut/bolt using an impact screwdriver or pliers.
Set Nut/bolt Installation Note
Install a new set nut/bolt and tighten it until the neck of the nut/bolt is cut.
Mazda 6 Service Manual: Parking brake (lever type) removal/installation
1. Remove the center console. (See CONSOLE REMOVAL/INSTALLATION.)
2. Remove the rear seat cushion (4SD) or rear seat (5HB) . (See REAR SEAT
REMOVAL/
INSTALLATION.)
3. Remove the exhaust pipe bracket.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6 ...
Mazda 6 Service Manual: Operating Tips for CD Player
Condensation phenomenon
Immediately after turning on the heater when the vehicle is cold, the CD or optical
components (prism and lens) in the CD player may become clouded with condensation.
At this time, the CD will eject immediately when placed in the unit. A clouded CD
can be corrected sim ...