WARNING
Always adjust the picture quality of the rear view monitor while the vehicle is stopped:
Do not adjust the picture quality of the rear view monitor while driving the vehicle. Adjusting the picture quality of the rear view monitor such as brightness, contrast, color, and tint while driving the vehicle is dangerous as it could distract your attention from the vehicle operation which could lead to an accident.
Picture quality adjustment can be done while the shift lever is in reverse (R).
There are four settings which can be adjusted including, brightness, contrast, tint, and color.
When adjusting, pay sufficient attention to the vehicle surroundings.
1. Select the icon on the screen
to display the tabs.
2. Select the desired tab item.
3. Adjust the brightness, contrast, tint, and color using the slider.
If you need to reset, press the reset button.
4. Select the icon on the screen
to close the tab.
Mazda 6 Owners Manual: Front lower arm (rear) removal/installation
1. Remove the front crossmember component. (See FRONT CROSSMEMBER
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.)
Front Lower Arm (Rear) Ball Joint Removal N ...
Mazda 6 Owners Manual: Oil cooler flushing
Note
The contaminated cooler line (oil pipes and hoses) and auxiliary
cooler must be flushed completely when ATX is overhauled or replaced.
1. Remove the two oil cooler line hoses and apply air pressure of 196 kPa
{2.0 kgf/cm2, 28 psi} from the return hose (pipe) side.
Caution
Power ...