Mazda 6 Service Manual: Power outside mirror disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Outside Mirror Glass Disassembly Note
1. Press area A of the glass so that area B moves toward you.
2. Insert a screwdriver into the notch and remove the glass from the mirror base.
Cover Disassembly Note
Pull off the mirror holder tab with a screwdriver and press the mirror cover tab downward.
Outside Mirror Glass Assembly Note
Press the mirror into the base so that the pin does not dislodge.
Power outside mirror removal/installation
1. Disconnect the negative battery cable.
2. Remove the inner garnish.
3. Remove the front door trim.
4. Disconnect the power outside mirror connector.
5. Remove the screws and the mirror retent ...
Power outside mirror inspection
1. Disconnect the power outside mirror connector.
2. Apply battery positive voltage to the power outside mirror terminals and
inspect the operation of the power outside mirror.
If not as specif ...
Other materials:
Mazda 6 Service Manual: No.3 passenger-side air bag cut-off indicator light does not illuminate
Diagnostic Procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure connec ...
Mazda 6 Service Manual: Headlight zeroset
Note
When the configuration is not set for the auto leveling control unit,
headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Connect the SST (WDS or equivalent) to the DLC-2.
4. Turn t ...