Drivers side
1. Remove the driver-side front door trim.
2. Connect the power window main switch connector.
3. Measure the voltage at the power window main switch terminals as indicated below.
4. Disconnect the power window main switch connector before inspecting for continuity at terminals 1M (1J*2) and 1F (1L*2).
Terminal voltage list (Reference)
*1 : With rear power window system (L.H.D.)
*2 : Without rear power window system (L.H.D.)
*3 : R.H.D.
Except drivers side
1. Turn the power-cut switch to UNLOCK.
2. Inspect for continuity between the power window main switch terminals using an ohmmeter.
Mazda 6 Service Manual: Smart Brake Support (SBS) (Some models)
The Smart Brake Support (SBS) system alerts the driver of a possible collision
using a display and warning sound if the radar sensor (front) and the Forward Sensing
Camera (FSC) determine that there is the possibility of a collision with a vehicle
ahead while the vehicle is being driven at abo ...
Mazda 6 Service Manual: Fuel pump unit removal/installation
Warning
Fuel line spills and leakage are dangerous. Fuel can ignite and
cause serious injuries or death and damage. Fuel can also irritate skin and
eyes. To prevent this, do not damage the sealing surface of the fuel pump
unit when removing or installing.
Caution
Disconnecting/co ...