Mazda 6 Service Manual: Power window motor inspection
Drivers Side
1. Disconnect the power window motor connector.
2. Apply battery positive voltage to the power window motor terminals E and F and inspect the operation the power window motor operation.
- If not as specified, replace the power window motor.
3. Apply battery positive voltage
to the power window motor terminal D and connect terminal C to ground.
4. Measure the voltage at terminal B and A while performing Step 3.
- If not as specified, replace the power window motor.
Voltage
Pulse wave: MAX. 5 V, MIN. 0 V
Except Driver's Side
Apply battery positive voltage to the power window motor terminals and inspect the operation of the power window motor.
- If not as specified, replace the power window motor.
Power window motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door trim or rear door trim.
3. Disconnect the power window motor connector.
4. Remove the bolts.
5. Remove the power window motor f ...
Other materials:
Mazda 6 Service Manual: Operating Tips for Audio System
WARNING
Always adjust the audio while the vehicle is stopped: Do not adjust
the audio control switches while driving the vehicle. Adjusting the audio while
driving the vehicle is dangerous as it could distract your attention from the vehicle
operation which could lead to a serious accident. E ...
Mazda 6 Service Manual: Starting a Flooded Engine
If the engine fails to start, it may be flooded (excessive fuel in the engine).
Follow this procedure:
1. If the engine does not start within five seconds on the first try, wait ten
seconds and try again.
2. Make sure the parking brake is on.
3. Depress the accelerator all the way and hold it ...