Mazda 6 Service Manual: Power window regulator removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door glass/rear door glass.
3. Remove the front door speaker/rear door speaker.
4. Remove the power window motor.
5. Remove the nuts.
6. Insert hand through the speaker installation hole, rotate the regulator drum housing in the direction shown in the figure and disengage the regulator drum housing from the door unit connection hooks.
7. Remove the power window regulator from the speaker installation hole.
8. Install in the reverse order of removal.
Power window subswitch inspection
1. Inspect for continuity between the power window subswitch terminals.
If not as specified, replace the power window subswitch.
...
Power window motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door trim or rear door trim.
3. Disconnect the power window motor connector.
4. Remove the bolts.
5. Remove the power window motor f ...
Other materials:
Mazda 6 Service Manual: Engine tune-up
IGNITION TIMING INSPECTION
Note
Ignition timing is not adjustable.
Ignition timing verification requires WDS or equivalent.
1. Turn off the electrical loads.
2. Warm up the engine as follows.
(1) Start the engine.
(2) Maintain the engine speed at approx. 3,000 rpm until the
cooli ...
Mazda 6 Service Manual: Power Moonroof Reset Procedure
If the battery is disconnected, the moonroof will not operate. The moonroof will
not operate correctly until it is reset.
Carry out the following procedure to reset the moonroof and resume operation:
1. Switch the ignition ON.
2. Press the tilt switch, to partially tilt open the rear of the moo ...