Mazda 6 Service Manual: Power window switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door trim or rear door trim.
3. Remove the screws, then the power window switch.
4. Install in the reverse order of removal.
Door glass position change procedure
Note
After performing the following procedure, verify that the two-step
down function operates normally and the door glass position has changed. If
the two-step down function does not operat ...
Power window main switch inspection
Drivers side
1. Remove the driver-side front door trim.
2. Connect the power window main switch connector.
3. Measure the voltage at the power window main switch terminals as indicated
below.
4. ...
Other materials:
Mazda 6 Service Manual: Warning Indication/Warning Lights
These lights turn on or flash to notify the user of the system operation status
or a system malfunction.
*1 The light turns on when the ignition is switched on for an operation check,
and turns off a few seconds later or when the engine is started. If the light does
not turn on or remai ...
Mazda 6 Service Manual: Remote handle lever removal/installation
4SD
1. To remove the remote wire, remove the trunk side trim.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
5HB
1. To remove the remote wire, remove the trunk side upper trim and trunk side
trim.
2. Remove in the order indicated in the table.
...