Mazda 6 Service Manual: Rear beltline molding installation
1. Press the clip at the C section into the body.
2. Press in the B section of the rear beltline molding along the direction (1) to attach it to the body.
3. Press the clip at the A section in and attach the rear beltline molding.
Note
- If the rear beltline molding is difficult to attach, apply soapy water.
Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B ...
Roof molding removal
1. Detach the clips which secure A and B sections of roof molding, using a
screwdriver or equivalent tool.
2. While pulling the roof molding up, detach the fit for the T stat of the A
section a ...
Other materials:
Mazda 6 Service Manual: Active Adaptive Shift (AAS)
Active Adaptive Shift (AAS) automatically controls the transaxle shift points
to best suit the road conditions and driver input. This improves driving feel. The
transaxle may switch to AAS mode when driving up and down slopes, cornering, driving
at high elevations, or depressing the accelerato ...
Mazda 6 Service Manual: Side air bag module removal/installation
Warning
Handling the air bag module improperly can accidentally deploy the
air bag module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE
WARNINGS before handling the air bag module. (See SERVICE WARNINGS.)
Warning
If the side air bag module is installed with debris in ...