Mazda 6 Service Manual: Rear finisher removal/installation
1. Remove the trunk lid trim (4SD).
2. Remove the liftgate lower trim (5HB).
3. Remove the nuts.
4. Pull the rear finisher toward you, then disengage clip A from the body.
5. Install in the reverse order of removal.
Extractor chamber removal/installation
1. Remove the rear bumper. (See REAR BUMPER REMOVAL/INSTALLATION.)
2. Remove the left side trunk side trim.
3. Remove the screw.
4. Squeeze the clips with your fingers and remove the extractor cham ...
Rear spoiler removal/installation
1. Remove the trunk lid trim. (4SD)
2. Remove the liftgate lower trim. (5HB)
3. Remove the bolts.
4. Disconnect the high-mount brake light connector. (4SD)
5. Remove the rear spoiler.
6. Instal ...
Other materials:
Mazda 6 Service Manual: Front lower arm (front) removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Front Lower Arm (Front) Ball Joint Removal Note
Separate the ball joint from the knuckle using the SSTs.
Front Lower Arm (Front) Bushing (Inner Side) Removal Note
Press the bushing (inner side) out ...
Mazda 6 Service Manual: Locking, Unlocking with Door- Lock Knob
Operation from inside
To lock any door from the inside, press the door-lock knob.
To unlock, pull it outward. This does not operate the other door locks.
NOTE
The red indication can be seen when the door-lock knob is unlocked.
Operation from outside
To lock the rear and front passenger doo ...