Mazda 6 manuals

Mazda 6 Service Manual: Rear heat duct removal/installation

1. Turn over the front floor covering. (See FRONT FLOOR COVERING REMOVAL/INSTALLATION.)

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Heater core inspection
1. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION.) 2. Remove the heater core from the A/C unit. 3. Inspect for cracks, damage, and coolant leakage. If any problems are found, replace t ...

A/c compressor removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the right side splash shield and mudguard (L.H.D. only). 4. Loosen ...

Other materials:

Mazda 6 Service Manual: Recommendations for Shifting
Upshifting For normal acceleration and cruising, Mazda recommends these shift points: *1 Always observe local speed limit regulations. Downshifting When you must slow down in heavy traffic or on a steep upgrade, downshift before the engine starts to overwork. This gives better acceleration w ...

Mazda 6 Service Manual: Hill Launch Assist (HLA)
Hill Launch Assist (HLA) is a function which assists the driver in accelerating from a stop while on a slope. When the driver releases the brake pedal and depresses the accelerator pedal while on a slope, the function prevents the vehicle from rolling. The braking force is maintained automatic ...

© 2016-2024 Copyright www.mazda6info.net