1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Rear Map Light Removal Note
1. Insert a tape-wrapped flathead screwdriver into the gap between the headliner and the rear map light.
2. Push the hooks to remove the rear map light.
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm removal/installation
Caution
When replacing the ABS (ABS/TCS) HU/CM, configuration procedure
must be done before removing the ABS (ABS/TCS) HU/CM. If configuration is
not completed before removing the ABS (ABS/TCS) HU/CM, TCS will not work
properly (with TCS model).
Do not drop the ABS (ABS/TCS) HU/CM. Re ...
Mazda 6 Service Manual: Wheel hub, hub spindle removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (body side) and fix it to an appropri ...