Mazda 6 Service Manual: Rear suspension

Transverse member removal/installation

1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. Transverse Cover Installation Note 1. Install the transverse cover. 2. Stake area A as shown in the f ...

Rear shock absorber removal/installation

Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Other materials:

Mazda 6 Service Manual: Recommended Tire Inflation Pressure
On the tire label you will find the recommended tire inflation pressure in both kPa and psi for the tires installed as original equipment on the vehicle. It is very important that the inflation pressure of the tires on your vehicle is maintained at the recommended pressure. You should check t ...

Mazda 6 Service Manual: Plastic Part Maintenance
When cleaning the plastic lenses of the lights, do not use gasoline, kerosene, rectified spirit, paint, thinner, highly acidic detergents, or strongly alkaline detergents. Otherwise, these chemical agents can discolor or damage the surfaces resulting in a significant loss in functionalit ...