Specification (Unloaded)*1
Normal
Elevated*3
*1 : Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.
*2 : Difference between left and right must not exceed 1°30'.
*3 : Distance between wheel center and fender brim is 392 mm {15.4 in} (reference value).
Note
Camber Adjustment
1. Loosen the cam nut on the lower arm.
2. Turn the adjusting cam bolt to provide the correct camber angles as indicated.
3. Tighten the cam nut.
Tightening torque 86.2-116.6 N·m
{8.79-11.88 kgf·m, 63.58-85.99 ft·lbf}
Total Toe-in Adjustment
1. Loosen the locknut of the lateral link.
2. Adjust the toe-in turning the adjusting link.
Specification
Total Toe-in: 2±4 mm {0.08±0.16 in}
Note
3. Tighten the locknut.
Tightening torque 68.6-98.1 N·m
{7.0-10.0 kgf·m, 50.6-72.3 ft·lbf}
Mazda 6 Service Manual: Input/turbine speed sensor inspection
Caution
Water or foreign objects entering the connector can cause a poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cl ...
Mazda 6 Service Manual: Lane-Change Signals and Three-Flash Turn Signal
Lane-Change Signals
Move the lever halfway toward the direction of the lane change—until the indicator
flashes— and hold it there. It will return to the off position when released.
Three-Flash Turn Signal
After releasing the turn signal lever, the turn signal indicator flashes three
times ...