1. For the 4SD, remove the following parts:
(1) Remove the headliner.
(2) Remove the rear package trim.
2. For the 5HB, remove the following parts.
(1) Remove the rear wiper arm and blade.
(2) Remove the liftgate lower trim.
3. Apply protective tape along the edge of the body to protect it from damage.
4. Cut the lip of the rear window molding using a razor.
Warning
Note
Not Reusing Glass
Note
1. Use a SST
, and insert the blade into the sealant.
2. Pull through the sealant around the edge of the glass.
3. Remove the glass.
Reusing Glass
Note
1. Make a hole through the sealant, avoiding pins, from the inside of the vehicle using an awl.
2. Pass the SST
(piano wire) through the hole.
Warning
3. Wind each end of the SST
(piano wire) around a bar.
Note
4. Working with another person, saw through the sealant around the edge of the glass.
5. Remove the rear window glass.
6. Remove the pins from the glass.
7. Remove the rear window molding from the glass.
Mazda 6 Service Manual: Dtc c1955, c1956
Caution
When attaching the tester lead to the DSC HU/CM connector the SST
(49 G066 004) must be used.
Diagnostic procedure
...
Mazda 6 Service Manual: Combine sensor removal/installation
Caution
Be careful and do not allow the combine sensor to fall. If by
chance it is subjected to strong impact, replace it.
1. Remove the center console.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, perform the comb ...