Mazda 6 Service Manual: Rear wiper motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION.)
3. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE ADJUSTMENT.)
Rear washer motor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Connect battery positive voltage to the terminal B and ground to the
terminal A of th ...
Rear wiper motor inspection
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
3. Disconnect the rear wiper motor connector.
4. Connect battery positi ...
Other materials:
Mazda 6 Service Manual: High Beam Control System (HBC) (Some models)
The High Beam Control System (HBC) determines the conditions in front of the
vehicle using the Forward Sensing Camera (FSC) while driving in darkness to automatically
switch the headlights between high and low beams.
Refer to Warning/Indicator Lights.
While driving the vehicle at a speed of ab ...
Mazda 6 Service Manual: Magnetic clutch disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT.)
Bolt Removal/Installation Note
1. When removing or installing the bolt, hold the pressure plate in place as
shown ...