Mazda 6 Service Manual: Reassembly
- Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.
- If removed, these parts should be replaced with new ones:
- Oil seals
- Gaskets
- O-rings
- Lockwashers
- Cotter pins
- Nylon nuts
- Depending on location:
- Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.
- Oil should be applied to the moving components of parts.
- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.
Cleaning of parts
All parts to be reused should be carefully and thoroughly cleaned in the
appropriate method.
Warning
Using compressed air can cause dirt and other particles to fly out
causing injury t ...
Adjustment
Use suitable gauges and/or testers when making adjustments.
...
Other materials:
Mazda 6 Service Manual: Foot Brake
This vehicle has power-assisted brakes that adjust automatically through normal
use.
Should power-assist fail, you can stop by applying greater force than normal
to the brake pedal. But the distance required to stop will be greater than usual.
WARNING
Do not coast with the engine stalled or t ...
Mazda 6 Service Manual: Sunvisors
When you need a sunvisor, lower it for use in front or swing it to the side.
Side Extension Sunvisors (Some models)
The visor extender extends the sunvisor's range of sun shading.
To use, pull it out.
CAUTION
When moving the sunvisor, retract the visor extender to its original position.
O ...