Mazda 6 Service Manual: Refrigerant pressure switch inspection
1. Install the SST
(gas charging set).
2. Disconnect the refrigerant pressure switch connector.
3. Verify the high-pressure side reading of the SST
(manifold gauge) and continuity between the terminals of the refrigerant pressure switch.
- If not as specified, replace the refrigerant pressure switch.
Triple-pressure Type
Dual-pressure Type
Refrigerant pressure switch removal/installation
1. Remove the battery.
2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.)
3. Loosen the refrigerant pressure switch using two spanners.
4. Remove in the order indicated i ...
Climate control unit removal
1. Disconnect the negative battery cable.
2. Disconnect the air mix and airflow mode wires from each wire clamp and
link. (Manual air conditioner)
3. Remove the center panel. (See CENTER PANEL MOD ...
Other materials:
Mazda 6 Service Manual: Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the
connectors.
2. Measure the voltage at the theft-deterrent control module terminals as
indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting
for continuity at terminals L, Q, S, T, a ...
Mazda 6 Service Manual: Power outside mirror disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Outside Mirror Glass Disassembly Note
1. Press area A of the glass so that area B moves toward you.
2. Insert a screwdriver into the notch and remove the glass from the mirror
base.
Cove ...