Mazda 6 Service Manual: Regulator handle removal
Remove the regulator handle clip using a rag as shown.
Inner handle removal/installation
1. Remove the front door trim.
2. Using a flathead screwdriver, press and hold the hook in the direction
indicated by arrow (1), and pull the shaft in the direction indicated by arrow
(2), remove ...
Regulator handle installation
1. Install the clip in the regulator handle.
2. Close the door glass fully and push the regulator handle on as shown. ...
Other materials:
Mazda 6 Service Manual: Rear wheel alignment
Specification (Unloaded)*1
Normal
Elevated*3
*1 : Engine coolant and engine oil are at specified level. Spare tire, jack
and tools are in designated position.
*2 : Difference between left and right must not exceed 1°30'.
*3 : Distance between wheel center and fender brim is 392 mm {15.4 ...
Mazda 6 Service Manual: Cigarette lighter removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Socket Removal Note
1. Insert a tape-wrapped screwdriver into the socket hole, then press against
the ring protrusion to lift the socket toward you.
2. As ...