Mazda 6 Service Manual: Resistor removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment.
3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
Blower motor inspection
Connect battery positive voltage to terminal A and ground to terminal B of
the blower motor and verify its operation.
If not as specified, replace the blower motor.
...
Resistor inspection
Verify that the resistance between the terminals of the resistor is as shown
in the table.
If not as specified, replace the resistor.
POWER MOS FET REMOVAL/INSTALLATION
(See RESISTOR REM ...
Other materials:
Mazda 6 Service Manual: Rear View Monitor Operation
The operation of the rear view monitor when reversing the vehicle varies depending
on the traffic, road, and vehicle conditions. The amount of steering and the timing
also varies depending on conditions, so confirm the surrounding conditions directly
with your eyes and steer the vehicle in acc ...
Mazda 6 Service Manual: Clutch master cylinder disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Snap Ring Disassembly/Assembly Note
Hold the piston down using a cloth-wrapped pin punch.
If disassembling, remove the snap ring; if assembling, install it.
...