Mazda 6 manuals

Mazda 6 Service Manual: Seat back striker removal/installation

Mazda 6 Service Manual / Body / Seat / Seat back striker removal/installation

1. Remove the tire house trim.

2. Remove the trunk side upper trim and trunk side lower trim.

3. Remove the bolts.


4. Remove the seat back striker.

5. Install in the reverse order of removal.

Remote handle lever removal/installation
4SD 1. To remove the remote wire, remove the trunk side trim. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 5HB 1. To remove the remote wire, remo ...

Power seat switch inspection
1. Disconnect the power seat switch connector. 2. Disconnect the rear tilt motor connector. 3. Inspect for continuity between the power seat switch connector terminals using an ohmmeter. If no ...

Other materials:

Mazda 6 Service Manual: No.2 air bag system warning light is illuminated all the time
Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connec ...

Mazda 6 Service Manual: Variable intake-air system (vis) control solenoid valve inspection (l3)
1. Remove the VIS control solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 2. Inspect airflow between the ports under the following conditions. If not as specified, replace the VIS control solenoid valve. If as specified, carry out the Circuit Open/Short Inspection. Circ ...

© 2016-2024 Copyright www.mazda6info.net