Mazda 6 Service Manual: Seat warmer switch removal/installation
1. Disconnect the negative battery cable.
2. Remove the brake boots panel. (See CONSOLE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Seat Warmer Switch Removal Note
Squeeze the tabs of seat warmer switch and pull it forward to remove it.
Recliner motor inspection
1. Disconnect the recliner motor connector.
2. Inspect the recliner motor operation when B+ is applied to the terminal as
shown.
If not as specified, replace the seat cushion frame.
...
Seat warmer switch inspection
1. Remove the seat warmer switch.
2. Inspect for continuity between the seat warmer switch terminals using an
ohmmeter.
If not as specified, replace the seat warmer switch.
Drivers side
...
Other materials:
Mazda 6 Service Manual: Refrigerant pressure switch inspection
1. Install the SST (gas charging set).
2. Disconnect the refrigerant pressure switch connector.
3. Verify the high-pressure side reading of the SST (manifold gauge)
and continuity between the terminals of the refrigerant pressure switch.
If not as specified, replace the refrigerant pressure ...
Mazda 6 Service Manual: Drive shaft (mtx) disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Clip Disassembly Note
1. Mark the drive shaft and outer ring for proper assembly.
Caution
Mark with paint; do not use a punch.
2. Remove the clip.
Balls, Inner Ring, Cage Disassembl ...