1. Turn the ignition switch to ON (engine OFF).
2. With the brake pedal depressed, verify that there is a "click" at each range when shifted.
3. Verify that the selector lever can be shifted.
4. Verify that there is a "click" at each position when shifted from P position to L range.
5. Verify that the positions of the selector lever and the indicator are aligned.
6. Verify that the vehicle operates in each selected range.
Mazda 6 Service Manual: Roof molding installation
1. Attach the roof molding to the T stud at the A section.
2. Press in the roof molding along the direction (1) shown in the figure and
attach it to the clip A at the B section.
3. Hook the roof molding to the clip B at the C section, press it in, and
attach the roof molding to the clip B.
...
Mazda 6 Service Manual: Wheel hub, steering knuckle pre-inspection
Wheel Bearing Play Inspection
1. Position a dial indicator against the wheel hub.
2. Push and pull the wheel hub by hand in the axial direction and measure the
wheel bearing play.
Maximum wheel bearing play
0.05 mm {0.002 in}
3. If the bearing play exceeds the specification, replace and tig ...