1. Remove the adhesive remaining on the side protector (if it will be reused) and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector (if it will be reused) and the body.
3. Attach double-sided adhesive tape to the side protector as shown (if it will be reused).
Clearancea: 30.0 mm {1.18 in}b: 3.0 mm {0.11 in}c: 12.0 mm {0.47 in}d: 3.0 mm {0.11 in}e: 3.0 mm {0.11 in}f: 1.0-3.0 mm {0.04-0.11 in}g: 5.0 mm {0.19 in}h: 2.0 mm {0.07 in}
4. Peel off the backing paper from the double-sided adhesive tape and attach the side protector onto the body as shown.
Clearance
a: 1.2-4.2 mm {0.05-0.16 in} b: 3.2-6.2 mm {0.13-0.24 in}
Mazda 6 Service Manual: Coil removal/installation
Note
Do not remove the coil unless you are replacing it.
When only the coil is replaced, the immobilizer system reprogram
procedure is not necessary.
1. Disconnect the negative battery cable.
2. Remove the column cover.
3. Remove in the order indicated in the table.
4. Install in ...
Mazda 6 Service Manual: Rear door trim removal/installation
1. Disconnect the negative battery cable if equipped with power window
system.
2. Remove the regulator handle if equipped.
3. Open the cap using a small screwdriver, then remove the screw.
4. Remove the inner handle cover.
5. Remove the cover, then remove screw.
6. Disengage clips A from th ...