Mazda 6 Service Manual: Side protector removal
1. Pry the side protector end 20-30 mm {0.8-1.1 in}
using a flathead screwdriver or a razor.
Warning
- Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
Note
- The side protector is installed with double-sided adhesive tape. If the side protector is difficult to remove, soften the double-sided adhesive tape using a hot air blower.
2. Pull the side protector toward you, then remove it.
Rear door garnish installation
Note
Double-sided adhesive tape has already been attached to the new
rear door garnish.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
...
Side protector installation
1. Remove the adhesive remaining on the side protector (if it will be reused)
and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the side protector
(if it will ...
Other materials:
Mazda 6 Service Manual: Recording of Vehicle Data
This vehicle is equipped with a computer which records the following main vehicle
data related to vehicle controls, operation, and other driving conditions.
Recorded data
Vehicle conditions such as engine speed and vehicle speed
Driving operation conditions such as accelerator and brake ped ...
Mazda 6 Service Manual: Manual transaxle removal/installation
1. Remove the battery, battery tray and battery bracket.
2. Remove the air cleaner compornent. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
3. Remove the wheels, tires and splash shields.
4. Remove the under cover.
5. Remove the steering gear and power steering pipe. (See STEERING GEAR AND
...