Mazda 6 Service Manual: Solar radiation sensor inspection
1. Shine an incandescent light (60 W)
on the solar radiation sensor from a distance of approximately 100 mm {3.94 in}.
2. Connect positive (+) lead to terminal A and negative (−) lead to terminal B of the solar radiation sensor.
- If the output voltage is not above 0.45 V
, replace the solar radiation sensor.
Solar radiation sensor removal/installation
1. Disconnect the negative battery cable.
2. Remove the solar radiation sensor from the dashboard using a tape-wrapped
flathead screwdriver.
3. Install in the reverse order of removal. ...
Ambient temperature sensor removal/installation
1. Disconnect the negative battery cable.
2. Remove the radiator grille. (See RADIATOR GRILLE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse ord ...
Other materials:
Mazda 6 Service Manual: No.8 no cool air
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor contact points are the cause of any intermittent malfunctions.
If there is a problem, check to make sure connectors, terminals ...
Mazda 6 Service Manual: Locking, Unlocking with Door- Lock Knob
Operation from inside
To lock any door from the inside, press the door-lock knob.
To unlock, pull it outward. This does not operate the other door locks.
NOTE
The red indication can be seen when the door-lock knob is unlocked.
Operation from outside
To lock the rear and front passenger doo ...