Resistance Inspection (On-Vehicle Inspection)
Caution
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
3. Disconnect the transaxle connector.
Note
4. Measure the resistance between the following terminals.
ATF temperature: -40-150 °C {-40-302 ° F}
5. Connect the transaxle connector.
6. Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
7. Connect the negative battery cable.
Operating Inspection
1. Disconnect the transaxle connector.
Caution
Note
2. Apply battery positive voltage to terminals A,B,C, F or G and battery negative voltage to GND, and verify that operating sound is heard from solenoid.
- If the transaxle harness is okay, perform the resistance inspection (off-vehicle inspection).
- If there is a problem, repair or replace the transaxle harness.
3. Apply battery positive voltage to terminal D and battery negative voltage to terminal I, and verify that operating sound is heard from solenoid.
- If transaxle harness is okay, perform the resistance inspection (off-vehicle inspection)
- If there is a problem, repair or replace the transaxle harness.
Resistance Inspection (Off-Vehicle Inspection)
1. Remove the control valve body. (See SOLENOID VALVE REMOVAL/INSTALLATION.)
2. Measure the resistance of each solenoid valve individually.
3. Install the control valve body. (See SOLENOID VALVE REMOVAL/INSTALLATION.)
Pressure control solenoid
Resistance
2.4-7.3 ohms
(ATF temperature: -40-150 ° C {-40-302 °F})
Shift solenoid A, B, C
Resistance
1.0-4.2 ohms
(ATF temperature: -40-150 ° C {-40-302 °F})
Shift solenoid D, E
Resistance
10.9-26.2 ohms
(ATF temperature: -40-150 ° C {-40-302 °F})
Mazda 6 Service Manual: Cruise Control Function
While this function is operating, the headway control operation is canceled and
only the cruise control function operates.
The vehicle speed can be set more than about 25 km/h (16 mph).
Use the cruise control function on expressways and other highways which do not
require a lot of repeated acc ...
Mazda 6 Service Manual: Front drain hose installation
Caution
If the front drain hose is pinched or bent anywhere, the water in the hose
may not discharge and enter the inside of the vehicle. During and after
installation of the trims and the headliner, always make sure there is no
interference with the front drain hose. Fix any problem if found ...