1. Disconnect the negative battery cable.
2. Remove the plug hoie plate.
3. Disconnect the high-tension lead.
4. Remove the spark plugs using the plug-wrench.
5. Install the spark plugs using a plug-wrench.
Tightening torque: 10-24 N·m {1.1-2.4kgf·m, 8-17ft·lbf}
6. Install the plug hole plate.
Caution
(1) To position the plug hole plate, grasp the rubber 1 and 2, as shown in the figure, with your hands and press them in.
(2) Route the accelerator cable more towards the center of the plug hole plate underside to avoid the rib area as shown in the figure.
(3) Grasp rubber 3 with your hand and press it in.
(4) Grasp clips 4 and 5 with your hands and press them in.
7. Connect the negative battery cable.
Mazda 6 Service Manual: Front shock absorber inspection
1. Remove the front shock absorber from the vehicle.
2. Inspect for damage and oil leakage.
3. Inspect the rubber bushing for deterioration and wear.
4. Compress and extend the shock piston at least three times. Verify that the
operational force does not change and that there is no unusual nois ...
Mazda 6 Service Manual: Cup Holder
WARNING
Never use a cup holder to hold hot liquids while the vehicle is moving:
Using a cup holder to hold hot liquids while the vehicle is moving is dangerous.
If the contents spill, you could be scalded.
Do not put anything other than cups or drink cans in cup holders:
Putting objects othe ...