1. Remove the stabilizer control link from the vehicle.
2. Inspect for bending and damage.
3. Measure the ball joint starting torque.
(1) Rock the ball joint stud side to side 10 times.
(2) Rotate the ball joint stud 10 times.
(3) Measure the starting torque using a suitable Allen socket and a torque wrench.
Starting torque
0.23-0.47 N·m
{2.4-4.7 kgf·cm, 2.1-4.1 in·lbf}
Mazda 6 Service Manual: Dtc clearing procedure
1. Start the on-board diagnostic test mode.
2. First press the POWER button, then simultaneously press AUDIO CONT button
for 2 seconds or more.
Caution
Before clearing the DTCs, be sure to enter all of them displayed
in the on-board diagnostic test mode in the Audio Repair Order Form. ...
Mazda 6 Service Manual: Cigarette lighter removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Socket Removal Note
1. Insert a tape-wrapped screwdriver into the socket hole, then press against
the ring protrusion to lift the socket toward you.
2. As ...