Mazda 6 Service Manual: Sunroof relay inspection
Note
- Sunroof relay is built in the sunroof motor.
1. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.)
2. Connect the sunroof switch connector.
3. Measure the voltage at the sunroof relay terminals as indicated below.
4. Disconnect the sunroof relay connector before inspecting for continuity at terminal 1G.
- If not as specified, inspect the parts listed under Action and the related wiring harnesses.
- If the parts and wiring harnesses are okay but the system still does not work properly, replace the sunroof relay.
5. Connect the negative battery cable.
Terminal voltage list (Reference)
Sunroof motor inspection
Motor
1. Remove the sunroof motor.
2. Apply battery positive voltage to the sunroof motor terminals and inspect
the operation of the sunroof motor.
If not as specified, replace the sunroof mot ...
Sunroof switch removal/installation
Note
The sunroof switch is together with the map light.
1. Disconnect the negative battery cable.
2. Remove the map light from the headliner.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Operating Tips for MP3
MP3 stands for MPEG Audio Layer 3, which is standardized voice compression established
by the ISO*1 working group (MPEG).
Use of MP3 allows for audio data to be compressed to approximately a tenth of
the source data size.
This unit plays files with the extension (.mp3) as MP3 files.
*1 Intern ...
Mazda 6 Service Manual: Transaxle range (tr) switch adjustment
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
Caution
Water or foreign objects entering the connector can cause a poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector w ...